AU-201H vs AU205H card value

[wseyller]

We were using the AU-201H which would output a 5 digit decimal value which the prox cards used. This is shown value in Papercut.

Now we get the AU-205H readers. An existing customer with many AU-201H card readers are getting another copier which will have the AU-205H reader. From experience these new readers produce a long value that looks hexadecimal but I doesn't I don't think it is because the 5 digit card value from a AU-201H reader doesn't match the AU-205H when converted to hexadecimal.

I imagine the the AU-205H could be reprogrammed somehow but I wouldn't know how. There is a way to change things when this reader is connected to a pc and it can be accessed with ip address 192.168.63.99. There are alot of complex settings in there and I have poked around with it for a few hours but I don't have a clue what I'm doing.

Is there anyone that has went thought the same changing over to the new reader?

[emujo]

Re: AU-201H vs AU205H card value

The AU-205 can be re-configured...
Here is a link to the drivers..http://www.hidglobal.com/drivers/21807



Here is the user guide...5127-902_d.3_omnikey_5x27ck_-_keyboard_wedge_user_guide_.pdf

[allan]

Re: AU-201H vs AU205H card value

Had to figure that out the hard way.

[wseyller]

Re: AU-201H vs AU205H card value

Thanks, I have the keyboard wedge guide and have already messed around with it. Guess I just don't understand it. I will probably read through it again later when I get a chance. Would be nice if there was a exported configuration that I could just load.