Hi,
I have a sc 49-01 code at the second time on the machine in last 2 years . This time it's going to sc in few days after developer change , I thing it's something wrong with adjustments . I remove the IC board and clean it inside from dust,then recall a factory initial data/HV adjustments/and adjustments after developer change.
Then controller starts properly , after receiving many files about few hours printing its crashes and controller error again . When I do LD offset adjustment do not coincides with test pattern no5 after do all adjustments for developer and I wonder why?Someones help?
I have a sc 49-01 code at the second time on the machine in last 2 years . This time it's going to sc in few days after developer change , I thing it's something wrong with adjustments . I remove the IC board and clean it inside from dust,then recall a factory initial data/HV adjustments/and adjustments after developer change.
Then controller starts properly , after receiving many files about few hours printing its crashes and controller error again . When I do LD offset adjustment do not coincides with test pattern no5 after do all adjustments for developer and I wonder why?Someones help?