Bizhub di2010

[Guest]

I have a bizhub di2010 that has been sitting for a while, upon boot I'm getting error code C0BA0

Any ideas?

[allan]

Re: Bizhub di2010

C0BA0
Elevator Motor Ascent/
Descent Drive Failure

To reset open and close the front door.

[tgrqy96]

Re: Bizhub di2010

Doesn't seem to have made a change. Still stuck on the same error screen

[allan]

Re: Bizhub di2010

Its got a finisher on it right?
Remove it if you need to if one of the finisher bins are not set correctly this could happen.

[darry1322]

Re: Bizhub di2010

You'll get this code if the exit trays for the finisher are not installed or if a tray is not level.

[tgrqy96]

Re: Bizhub di2010

I believe I'm missing some hardware for the finisher bins,
So what all do I need to remove to remove the finisher?
It's not used, so removing it is the easy option.


I apologize, I have a technical background but zero experiance with printers. Just looking for the proper way to remove the finisher.

[allan]

Re: Bizhub di2010

Open the finisher door and look for a square hole to poke your screwdriver in. It releases it, press in your screw driver while you pull.
The hole is about +- 10mm by 10mm.
Make sure the machine is switched off first.