[Misc] konica minolta bizhub 185 after changed developer and drum

[tfxro]

After I changed developer and drum and tcr adjust,machine is working about 20 pages.
After that blank copy is just like that(image).
I change corona, i change transfer roller, cleanig blade and same problems.
What happens?






IMG_20170220_153950.jpg

[rrrohan]

Re: konica minolta bizhub 185 after changed developer and drum

Did you rebuild the drum or changed the entire assy?

[tonerspot]

Re: konica minolta bizhub 185 after changed developer and drum

check developer roller, you have too fat "brush" on one side.

[tfxro]

Re: konica minolta bizhub 185 after changed developer and drum

Did you rebuild the drum or changed the entire assy?

I rebuild the drum

[tfxro]

Re: konica minolta bizhub 185 after changed developer and drum

check developer roller, you have too fat "brush" on one side.

I check but is uniform .

[katlyn]

Re: konica minolta bizhub 185 after changed developer and drum

Are you sure you don't forget anything, some contacts? Is it the proper drum ?

[service_man]

Re: konica minolta bizhub 185 after changed developer and drum

If you put the drum maybe KATUN, you have that problem.
I have the problem on bh 215, when I put new drum Katun, and I get that copie.
Put back old drum, and machine is working fine.

Regards