program for C353

[vale24]

Hi,
I have a customer who has C353 and often copy Identification card on both sith. The customer ask me how to make a program to copy both sides of ID card on one side of paper witn one pasing the paper through copier. I sow C252 with same program but I don't know how do this !
Thanks!

[ni311]

If the copier have the duplex option, just select from 'Simplex/Duplex' box on the touch screen, 1 -> 2. Put the ID card on the glass, press Start, flip the ID card, press Start again and you should get a sheet of paper printed on both sides. These basics operations are in the user manual, if you don't have it I can send it to you.

[vale24]

"on one side"

I've written that I want two sides of the ID card to be on one side (the same). I know what is 1>2 but this is other function.

[minimerlin]

Try using the COMBINE settings on the same screen as DUPLEX, set output as 2in1 then scan each side of the ID card ,on completion of scanning printout the single sheet.

[vale24]

But than copier zooming down the original on 71 %. I want them at 100%. I've seen that on C252 (it was made like a ready function - aditional) and I am mad with rage because I don't know how to do that.

[AjitN]

Id cards in 2 up

Try 2 up setting with original size A5 and copy % as 100 %.
After fist side scan, turn the ID card, scan and complete the job.

Ajitn

[tec966]

Ajitn you're right, but probably is better set the original size to A5R.

Tec

[AjitN]

Id cards in 2 up

tec 966
Yes you are correct, its my slipout not to mentioned A5R.

Thanks

Ajitn