If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
bizhub C554e FS-535 3-Hole Puchouts in Stapler Unit
Re: bizhub C554e FS-535 3-Hole Puchouts in Stapler Unit
Originally posted by copytechman
Interesting! I have 2 c754e's with fs535s and the ru units that do this, Chad's all over the bottom of the finisher on both, punch boxes secure, felts all straight, still don't really know why, it rarely causes an issue, the key op vacuums em up periodically. I have had to straighten the felts once in a while but that's pretty infrequent.
Thoughts?
A!
Same here. Dirty finishers in my experience; never caused an issue though (aside from all those filthy Chads turning the joint into a flophouse).
Comment