Hello,
I have installed a new Bizhub C227. I have never noticed this, but perhaps it has always been this way. While I was configuring the drivers, I have often noticed that in the standby phase, the fuser starts a preheat for about 10 seconds. Sometimes he does it after a few minutes in a row, sometimes a little time passes.
I imagine this happens to ensure a quick first print. But honestly, I have never noticed this until now.
I have installed a new Bizhub C227. I have never noticed this, but perhaps it has always been this way. While I was configuring the drivers, I have often noticed that in the standby phase, the fuser starts a preheat for about 10 seconds. Sometimes he does it after a few minutes in a row, sometimes a little time passes.
I imagine this happens to ensure a quick first print. But honestly, I have never noticed this until now.