BH-363, cannot find the settings for coin unit.

[Hansoon]

Like to put this machine in the local supermarket as a coin operated MFP. I still have several BH-350 as coin machines around, and they are easy to adapt to the coin unit. However, this BH-363 seems to be very different, and I cannot find in the tech manual how to set up the machine as a coin operated device. Any help please?

Hans

[Synthohol]

service mode, stop, 9
vendor mode (1/2) usually 2 i think.
oh and the 4 pin cable is usually on the right frame of the scanner if i remember.

[Hansoon]

service mode, stop, 9
vendor mode (1/2) usually 2 i think.
oh and the 4 pin cable is usually on the right frame of the scanner if i remember.

Thanks, the BH-363 seems different. I did already before: Service Mode > Stop-9, Billing Setting > Management Function Choice. But then I'm lost, cannot find any setting for a coin unit. Not as with the previous BH-350 models. There it says "Vender 1, message 1 for coin vender" ?

Hans

[Synthohol]

[oldschool]

When using a key counter and a vend unit, select key counter I/F vendor. I think some newer models used Vendor 1 rather than key counter I/F vendor. On old machines, Vendor 1 used to enable a serial protocol that was replaced by Vendor 2.