scan to smb question..

[Ditzah]

...
If you type the copiers IP address into your web browser, you can then go to the copiers web interface, click the FAX/SCAN button (doesn't look like a button, but it is), scroll down to the bottom of the page and click the 1st box - on the 3 dashed lines (they are links), follow the screens.
...

I have the same missing scan-to-SMB problem, but I also have problems making it appear. If I type the copier's IP address, I get what you see attached.
Nothing.
I have a brand-new C200.

[DocuSystems]

C-200

I suppose the first thing I would check is if SMB Scanning is enabled in the Administrator Mode Network Settings.

[brent]

I suppose the first thing I would check is if SMB Scanning is enabled in the Administrator Mode Network Settings.

I just went into administrator mode net setting and did not see anywhere that I could enable. did I miss it? there are 2 columns there b ut no smb


thanks

brent

[DocuSystems]

C200

Use the Assistant tool on the C200 by typing the IP address for the machine into the address bar in the web browser.
Log in as Administrator
Select the network tab
Select SMB from the left pane
There you will see the setting for enabling SMB Scanning. It's out lined in the bizhubC200UserGuideNetworkAdmin.pdf available on the KMBT website. Should also have been included on the User's Guide CDROM which came with the machine. There is also a software switch setting in the service mode in the event that this doesn't take care of it, you may want to check that as well.

[brent]

this whole thread is about a B 200 not a c 200 it is different. as I can't find the enable smb

brent

[DocuSystems]

Perhaps the C200 poster should start a new thread?

[KonicaNet]

Right bizhub 200, but the c200 will require a firmware update, and even then I do not recall if it can do SMB scanning. The machine was EXTREMELY limited when released and did not have plans for updating it's abilities, however they did increase the network capabilities with a firmware update that came out in the US a couple of months ago.

Hope this helps.

[delhi_ngg_rhc]

I have set up a shared file on my pc. i am running windows vista . and the instructions tell me to go the the mfp and hit the scan button. then direct imput. then scan to smb button. it simply is not there. I actually have an instruction sheet from my dsm. but the information is not correct. I am doing this as an exersize to get better at it. this is a brand new bizhub 200 that is in our shop. I have read some of your posts on scanning and I feel you guy's have the missing link. again. scan to smb. the machine has no hdd. and no fax unit for ip scanning. just plane jane scanning. thanks for your help in advance

brent frank

this need the setup of smb scan throw the machine
1 -setup ip and ping
2- go utiliy menu -} megm } 00000000 } admin 1/2
one touch email } select one touch
give the name } select SMB} ip destination pc} directory ( share file me pc)
} user name ( user pc desti.) } pass word user pc } complet by enter / enter

3- select the scan from the macine select one touch scan destination press start now m/c send scan.

i hope this will enough
thanks

[dellt]

Re: scan to smb question..

If smb option doest show on settings than you have to update the firmware of the copy machine its a fw bug .