If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
C0BA0..... finisher unplugged and still throwing code.
C0BA0..... finisher unplugged and still throwing code.
The finisher is completely pulled away from the 3102 and I still have the code. Turned machine off, unplugged and pulled the finisher completely away... I am so frustrated. Do I need to clear something out on the board?
According to my husband, "You're pretty smart for a girl."
You will never believe it.... Opened every door on the machine, hooked up finisher, rebooted and the darn thing started.
Good grief.
i read your 1st post and thought: i know this, just open the ddor an it will reset the code.....
it took me 1 day to figure that out when i had this problem
Comment