Ecm konica 7045

[pudgi300]

Have a Konica 7045 that boss got at auction. I can't get in service because of the ECM password. I have a printout that was with the machine that says the key op is 00000000 and other is 0000. I can hold down the p button all day and not get to screen for service password. Someone must have changed the password after the printout was made. Is there a powerup way to get in service mode so i can reset and get rid of the ecm . I never worked on 7045's just bizhub 1050 and c6500 ,canon Xerox. I also downloaded the manual about the ECM and if you have no password you are out of luck.

Thanks Warren

[nmfaxman]

Try 25 mode to get the ECM passwords.

[jeroen2005]

Go to the 36 mode-list output- there you can see the codes.
Hold help button en switch machine on.Enter 1234 then switch ecm off.

[pudgi300]

I can't get past the ecm screen asking me for a 5 digit password. Tried hitting the help button and can not even get to the key op mode. If i can get in service mode a can shut this thing off.
I have all the service guides,service manual and the doc for the ecm.

[pudgi300]

will try the help button thing again. Had to read it again sorry, Will report back



OK went back and held help button and power on enter 1234. . Went to ecm and turned it off. Why didn't i think of that??? Was that in the manual or something that is special info?? Thanks for the help and quick response.

Later Warren

[jeroen2005]

It is a kind of standaard 0000 or 1234 master key code 00000000 or 12345678

[cdleon]

hi friends,

i was working with Konica machines and remember that is in mode 25, you can change the password. Meke me know maybe i can help you, i have a service manual of konica 7020, y the same modes.