If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hold down the utility button until "enter access code" appears and enter 9272 then press start. Enter 25 mode. Go to soft switch mode. The number that you enter on the left is the switch number and number on the right is the bit number. Switch 3 bits 3&4 to a 1 will disable the T/S cleaning motor and charge cleaning motor. These motors don't last for very long, so we just disable them. It doesn't seem to cause any problems.
Comment