If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
hi...this error code appears after you clear the data in service mode...so you have to enter sevice mode
Utility+stop+0+0+stop+0+1....enter to ADJUST &specify the speed model from the table ypu'll find 21-18-16
select 21 for your model bizhub 210
i hope it's help my dear
error code C03FF in konica Minolta 210
Comment