Hello friends I want to install this copier with RJ45 conector but the configuration page shows 192.168.1.99 ip adress when I change it on the display, I put 10.10.0.155 ip adress,then I press intro.When the copier prints the configuration pages, the ip address doesn't change. How can I change ip address? thanks
-
-
Modify the IP adress as you described and than REBOOT machine with the power switch.
Hans“Sent from my Intel 80286 using MS-DOS 2.0”
-
try admin. network setting should be ok...Comment
-
don't foget to change ip gatewayComment
-
I did all that you above mencionated,the ip address, subnet-mask anf gate away change on the screen,but not on the configuration page.thanks.one friend told me that I can change ip address by internet. how can I do it? Is it corret?Comment
-
connect a laptop directly to the machine and set the laptop ip to the same range, then open a browser window and type the ip showing on the config sheet into the adress bar. this will let you access the web interface of the machine and change settingsComment
-
There are several methods of assigning the IP address on this machine. Check chapter 7 of your NIC operator manual. If you don't have one, here's the link:
Last edited by mascan42; 03-13-2010, 08:43 PM.Comment
-
...with a crossover cable ofcourse....connect a laptop directly to the machine
Don't get it, this machine is usually unproblematic. Set the IP-Adress and Subnetmask under Admin>Network and restart machine. That's it. We have had 100+ machines of these series, none of them had this problem. The only thing what can happen is that the NIC starts to fail but this is showing in lost pings, never until now with failing to accept new settings.
Hans“Sent from my Intel 80286 using MS-DOS 2.0”
Comment
-
...with a crossover cable ofcourse....
any rj45 cable usually works in my experience all you are do-ing is creating a vpnComment
Comment