I have a IKON creo 550 Powerpro 1.0. I purchased the 2.0 download and installed it.
Problem: After install and while the program boots up a screen gives an error: IK-FUSION Board error and another screen RIP=NULL.
I did completely uninstall the previous software before installing the new 2.0
I contacted IKON for the actual DVD's- but they were not much help.
Any thoughts?
Problem: After install and while the program boots up a screen gives an error: IK-FUSION Board error and another screen RIP=NULL.
I did completely uninstall the previous software before installing the new 2.0
I contacted IKON for the actual DVD's- but they were not much help.
Any thoughts?