When I send a print job to the c450 the data light blinks and the job never prints. This just started happening, any ideas?
-
-
What does it say in the job history? Is Account Track or Authentication enabled?Online Store is closed. Chip resetting is a thing of the past! Thank you to all my past customers.
Now into Ip TV KODI Boxes -
Or the job has been printed to a user/system box or secure print"Many years ago I chased a woman for almost two years, only to discover that her tastes were exactly like mine: we both were crazy about girls."
---Groucho Marx
Please do not PM me for questions related to Konica Minolta hardware.
I will not answer requests or questions there.
Please ask in the KM forum for the benefit of others to see the question and give their input.
Comment
-
There is nothing in job history and acct. track and auth enable are both off.Comment
-
Secure print is not being used.Comment
-
Maybe this is one for the NVRAM/NIC-reseting firmware-thingie?' "But the salesman said . . ." The salesman's an asshole!'
Mascan42
'You will always find some Eskimo ready to instruct the Congolese on how to cope with heat waves.'
Ibid
I'm just an ex-tech lurking around and spreading disinformation!Comment
-
Or just a wipe of the settings in tech rep, re-enter all the settings and so forth will correct it.
Might even be something as stupid simple as a poor network connection or failing port on a router."Many years ago I chased a woman for almost two years, only to discover that her tastes were exactly like mine: we both were crazy about girls."
---Groucho Marx
Please do not PM me for questions related to Konica Minolta hardware.
I will not answer requests or questions there.
Please ask in the KM forum for the benefit of others to see the question and give their input.
Comment
-
Try printing to it with a crossover cable first.
Try a firmware update second.
Try a Data Clear third.
Report back!Comment
-
Can you print the demo page?Comment
-
It will not print anythingComment
-
I hooked up a crossover cable and I still couldn't print.
How would I do a firmware update or a data clear?
Thanks for your help.Comment
-
Can be a memory issue. Do not remember exactly where, but there is a way in to control the memory that are two tipes, solded on the main board and normal kind also.
Is better for you to try this first.... In the minute that you're thinking of giving up, think about why you lasted so long ...Comment
-
If you are correct in saying that you can't even print the internal Demo page, then this is probably an issue that is best handled by a qualified technician. Trying to do firmware or NIC resets and not knowing exactly what your doing will most likely result in a dead machine.Online Store is closed. Chip resetting is a thing of the past! Thank you to all my past customers.
Now into Ip TV KODI BoxesComment
-
Is there a vending device attached? I've seen the exact symptom when one is attached. In Vendor 1 mode sometimes pass through printing does not work. There may be specific firmware needed or a soft switch that needs to be set. The hot line should know for sure. In vendor 2 mode there is a setting in admin/security to freely allow printing or to charge for it. In the case of charging for it, the print job has to be a secure print job.Jamex Tech Support: Saving the world one phone call at a time.Comment
-
Re: Sending print job to c450 konica minolta data light blinks
Whenevere i sent documents to print, the Konica Minolta c360 warms up for a period of time and just not printing, the data light keeps flashing and yet it's still not printing and unable to configure SMB/email scanning functions from public usermodeComment
Comment