Konica 8050 Sc45-20

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • FINECO

    #1

    Konica 8050 Sc45-20

    I have an error, what does this mean and how do I make it go away?

    Please Help.......
  • knightfall
    Senior Tech

    500+ Posts
    • Jul 2006
    • 633

    #2
    your Color registration correction results in abnormality. Would try first:
    1. Clean everything in the process unit(drum, charge, dv units) while in there inspect everything.
    2. Clean the color registration sensors.
    3. Run process control (Auto Gamma Adjust in 36 mode)
    other possibilities:
    PRBC or color registration shutters or the sensors PS8 & 9. use I/O to check sensors. Good luck.
    Don't do the following if you are not a technician.
    Last edited by knightfall; 11-22-2007, 04:13 AM.
    Get your facts first, and then you can distort them as much as you please.

    Comment

    • random

      #3
      The colour reg sensors are dirty (usually at the back) or the belt is stuffed.

      Comment

      • FINECO

        #4
        Konica 8050

        Thanks guys.
        I'm not a tech but I'll do my best..... worst case, I have to get someone come in..any clue what a service call will cost?

        Comment

        • knightfall
          Senior Tech

          500+ Posts
          • Jul 2006
          • 633

          #5
          will vary depending on what service company you go to, so shop around for best price. Good luck.
          Get your facts first, and then you can distort them as much as you please.

          Comment

          • Livebychance
            Technician
            • Dec 2007
            • 34

            #6
            After you do the above mentioned do a auto color registration in the service mode.

            36 mode
            Image Adj
            Timing adjust
            Auto Color Registration

            Comment

            Working...