I'v got msg that says I need to replace it,but,unit is in great condition,soo is there any way I can skip it?disable this error msg or something
Cheatzor :$
Cheatzor :$
-
-
Tere is now way to reset it.
If there is "IU resetor chip" available in this machine, it could be possible but i dont know sure.[Completed] Outaward, [Completed sertifications] C652,C552,C360,C280,C220,C35,C353,C203,C20p,C25 -
Anything without chip?Comment
-
Color is not 4 times harder... it's 65,000 times harder.
They call it "TECH MODE" for a reason. I have manual's and firmware for ya, course... you are going to have to earn it.Comment
-
As the post above stated put it in no stop mode or look on Ebay and buy a chip (a board on this IU) and change it but understand the black IU runs twice as long as the colors so you wont get the same life after reset as you would on a C,M or Y.Comment
-
No stop mode allow you to continue copying, but not remove "Change B imaging unit" messages.[Completed] Outaward, [Completed sertifications] C652,C552,C360,C280,C220,C35,C353,C203,C20p,C25Comment
-
get a tech to reset the chip,best bet would be a konica dealer they are more than likley the ones that rechipp image units 5min workComment
-
I am tech,I can enter tech mode..buyin chip is waste if i can stop it this way..Comment
Comment