Image Unit Warning c250

[repeatcopiers]

I put a good slightly used imaging unit into a bizhub c250, but the warning to replace is still there? Can I turn that off somewhere in the service mode?

[SPBE]

Re: Image Unit Warning c250

Not unless you reset the chip.

[bushy]

Re: Image Unit Warning c250

You will have to replace the chip as replacing the unit with another one will not reset the message.
The new chip has a program that resets the message but once it has reset that part of the chip becomes redundant and cannot be used a second time
You could replace the iu with a new one but as soon as you put that iu in a m/c the chip would not reset again.
Hope that is clear
Once a chip or an iu has been installed it will not reset the message more than once.

The chips are only about $15 to buy so dont sweat as you can more than cover your costs.

Good luck

Bushy

[ismailf]

Re: Image Unit Warning c250

Hi I have a Bizhub C250 machine, I am a novice.

Machine gives me the following message "need to replace image unit" Can this be bypassed?

Do I need to order another image unit?Which image unit should I order?Is it easy to install?Do I need to reset counters?

How do I used the control panel and view all error messages and configurations?

Kind Regards

[mervyn]

Re: Image Unit Warning c250

Read the previous post , you either need to rechip unit or replace it.

[ismailf]

Re: Image Unit Warning c250

Hi the picture on the screen shows yellow, magenta and cyan image unit. if they are replaced the message will go away?But from the previous post the message still appeared as he used a slightly used imaging unit and had to replace the chip. So it looks like I have to replace the image unit as well as the chip?

Thanking you for your help

[SPBE]

Re: Image Unit Warning c250

You only have to re-chip if you install a used IU.

[ismailf]

Re: Image Unit Warning c250

Hi
So new IU no need to reset chip. Is there a way to check these counters?

Regards