Konica Bizhub C220 C2 Firmware Setting

[tech51]

Re: Konica Bizhub C220 C2 Firmware Setting

Under my point of view new firmware's ( C2,C6) helps and are ok if your machines are for your use , but as logic end customers will call KM dealer's services after check the oil can icon, and this will not help too much to avoid their calls.
Is better to spend some $'s in chips and give an end solution ( with nothing flashing on their eyes ).
We have full line of chips including the C220,C280,C360 families for developing units in stock.
For any information don't hesitate to contact me sending private message.

But you would say that wouldn't you!!! My experience is that customers take no notice of the oil can, or any other message for that matter!!

[CHIPS HOME]

Re: Konica Bizhub C220 C2 Firmware Setting

Under my point of view new firmware's ( C2,C6) helps and are ok if your machines are for your use , but as logic end customers will call KM dealer's services after check the oil can icon, and this will not help too much to avoid their calls.
Is better to spend some $'s in chips and give an end solution ( with nothing flashing on their eyes ).
We have full line of chips including the C220,C280,C360 families for developing units in stock.
For any information don't hesitate to contact me sending private message.

[emujo]

Re: Konica Bizhub C220 C2 Firmware Setting

After firmware update, set softswitch 55 to hex "0C" and switch 51 to hex "F0", enhanced security set DC developer stop to "no stop". Emujo

[mervyn]

Re: Konica Bizhub C220 C2 Firmware Setting

This is explained in Tech Bulletin # 7528 dated 6/9/11 same for C220 C280 and C360

[Mooseface2r]

Re: Konica Bizhub C220 C2 Firmware Setting

Thanks for the input, got that C6 now aswell.... im getting confused with this if someone could clear it up

"

Switch No.: 51
Hex Assignment - 00: Life warning is displayed. (Default)
Hex Assignment - 10: Life warning is NOT displayed.

Switch No.: 51
Hex Assignment - 00: Life warning is displayed. (Default)
Hex Assignment - 20: Life warning is NOT displayed."

It says to change switch 51 to both 10 and 20 but you can only set it once so which one is best 10 or 20? and if you do put it to 20 does this include the colour ius and black drum?

Regards

[JSC]

Re: Konica Bizhub C220 C2 Firmware Setting

Your also better off upgrading to C6 as there are a lot of 'bugs' in the C2 firmware.

[emujo]

Re: Konica Bizhub C220 C2 Firmware Setting

it doesn't elimnate the need to replace drums, fuser,x-fer belt, it allows you to run past the life span. You still need to change out assys that no longer meet the customers CQ expectations. Dip switch 55 to 0C, switch 51 to F0, and enhanced security mode "life stop setting" to "no stop". (settings are only valid after firmware is in place). Don't forget to deselect "scanner" when updating firmware.

Above settings are for C360 only, setings are different for all 4 color families.

You will still see the oil can if anything has reached its end of life, but the MFP will continue to run.
Hope this helps with "lamens" terms. Emujo

[Mooseface2r]

Hi, Can somebody please explain to me what settings need to be changed when loading the C2 Firmware to eliminate the need to replace the Drums, Devs, Fusers ETC.

Iv got some docs on it from the firmware readme file but could someone please explain in lamens terms as it never seems to work.

Regards