[Error Code] strange problem Bh163

[blago_vd]

Hello everybody,
A client bring me in the workshop Bh163 with C0F32. There was not much developer in the developing section. I replaced drum, cleaning blade and developer. After running ATDC adjustment the machine displayed C0F33. So, after resetting the code the machine displayed C0F32 again. I replaced the ATDC sensor, but it was the same situation. The connections between the sensor and the PWB-A are OK.

[rex777mix]

Re: strange problem Bh163

Hello, you must change the old developer by a new one.

[blago_vd]

Re: strange problem Bh163

Already changed

[jbosman]

Re: strange problem Bh163

Hello everybody,
A client bring me in the workshop Bh163 with C0F32. There was not much developer in the developing section. I replaced drum, cleaning blade and developer. After running ATDC adjustment the machine displayed C0F33. So, after resetting the code the machine displayed C0F32 again. I replaced the ATDC sensor, but it was the same situation. The connections between the sensor and the PWB-A are OK.

Remove the IU-assembly make sure that you leveled out the developer, run ATDC gain again, if that doesn't work check your toner supply.