FS-608 attached to bizhub C550 Strange Paper Jam

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • MFPs R Now PCs
    MFP Tech & I.T. Manager

    100+ Posts
    • Jul 2011
    • 156
    #1

    [Jamming] FS-608 attached to bizhub C550 Strange Paper Jam

    It does not matter how slowly you go as long as you do not stop. –Confucius
    Tags: bizhub, bizhub c550, finisher, jam code, konica, konica minolta, minolta, paper, static, time
    • RRodgers
      Service Manager

      1,000+ Posts
      • Jun 2009
      • 1947
      #2
      Re: FS-608 attached to bizhub C550 Strange Paper Jam

      Latest firmware?
      Color is not 4 times harder... it's 65,000 times harder. They call it "TECH MODE" for a reason. I have manual's and firmware for ya, course... you are going to have to earn it.

        Comment

        • jackson
          Technician
          • Mar 2010
          • 19
          #3
          Re: FS-608 attached to bizhub C550 Strange Paper Jam

          I've have noticed a static build up in some folding units, if you put a meter from main body to folding unit anything below 12-15 ohms seems ok, mostly find 35 ohms plus a problem, ensure you make yourself a good earth. And it does pay to thoroughly clean the folding rollers as any slippage causes those jams.....Good luck

            Comment

            • methogod
              Senior Tech

              Site Contributor
              500+ Posts
              • Dec 2008
              • 919
              #4
              Re: FS-608 attached to bizhub C550 Strange Paper Jam

              having the same issue, i only use the C550/C650 for light printing, nothing heavy.

              Had 100 8 pages booklets, i would say medium coverage...

              24# navigator 8.5x11 SEF.

              will run 1-3 sets then jam.

              Looks like its the 2nd page is getting stuck due to static as mentioned above.


              How do you fix this? all consumables are like new....


              also i have never had to use a meter to measure static charge, also is this the charge while running or after the jam.


              thanks,

                Comment

                • westvandude
                  Technician
                  • Sep 2013
                  • 31
                  #5
                  Re: FS-608 attached to bizhub C550 Strange Paper Jam

                  After getting our C550 used with the FS-608 a couple months ago we've run hundreds of 32 page 11x17 stapled folded booklets no problem. Go to do a Z-fold on 8.5x11 20lb or 24lb and it prints fine, goes into finisher, does first fold, then second fold or top edge gets all wrinkled up looks like 3-4 attempted folds on that last 1/3 of the page. It jams up between the big lower grey rubber roller. If you pull down on the paper jam thingy on the lower output side of that big roller you can pull the paper out with a little effort. Not sure what's going on.

                  Mine shows about 6 ohms between main body and the pull out folding section. Advisable to throw an extra ground wire between the two?

                    Comment

                    • westvandude
                      Technician
                      • Sep 2013
                      • 31
                      #6
                      Re: FS-608 attached to bizhub C550 Strange Paper Jam

                      Ran a separate gnd wire between the two.... now have zero ohms. But didn't fix my z-fold jam. LOL

                        Comment

                        Previous template Next
                        Working...