The Extremely orrible bizhub 240f

[big jase]

i have one of these lovely machines that is stuck on the konica minolta screen the loading bar goes almost to the end (one section of complete) and just stays there, i found a TAD TAEU1100229EN00 that says its the PDL board but states on TAD that machine should boot up when PDL is disconnected ,mine doesnt just shows the same fault .Any ideas ?

[RRodgers]

Re: The Extremely orrible bizhub 240f

Try flashing it.

[didspip]

Re: The Extremely orrible bizhub 240f

Have had many of these with this fault. You need to re load the firmware.
There are three files required.
MB-750 Firmware version B9A0A0
OP-700 Firmware Version A5A0A0
Konica Minolta 240f Firmware Version D4A0A0
Use a USB stick with all three files, put the stick in and switch on - wait till complete.

[minimerlin]

Re: The Extremely orrible bizhub 240f

Have had many of these with this fault. You need to re load the firmware.
There are three files required.
MB-750 Firmware version B9A0A0
OP-700 Firmware Version A5A0A0
Konica Minolta 240f Firmware Version D4A0A0
Use a USB stick with all three files, put the stick in and switch on - wait till complete.

I have an idea that this fault may have been fixed one way or another...the post is a year old!

[JustManuals]

Re: The Extremely orrible bizhub 240f

I have an idea that this fault may have been fixed one way or another...the post is a year old!

Actually........It's only 6 months old.

[minimerlin]

Re: The Extremely orrible bizhub 240f

I stand corrected.....I keep forgetting that you chaps over the pond get the day and month backwards..lol.