Power on the Controller error

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • l-dog63
    Junior Member
    • Nov 2010
    • 4
    #1

    [Misc] Power on the Controller error

    I have a Bizhub C452 with an IC-409 Fiery. whenever printing anything above a couple of pages I get the 'Power on the Controller" display on the copier and the Fiery reset as if nothing was sent to it.
    Tags: bizhub c452, fiery, power
    • MCBIG
      Technician

      Site Contributor
      • Feb 2012
      • 36
      #2
      Re: Power on the Controller error

      If I ran into this issue myself, I would probably start by reloading the Fiery System code....

        Comment

        • emujo
          Field Supervisor

          2,500+ Posts
          • Jun 2009
          • 3009
          #3
          Re: Power on the Controller error

          Re-seat the video card, set the Fiery back to factory spec, re-do the install for the Fiery again. There are specifics instructions depending on if you are using the emperon controller for other than printing...You may also want to ensure you are using the correct Fiery driver for printing. Emujo
          If you don't see your question answered in the forum, please don't think it's OK to PM me for a personal reply...I do not give out firmware and/or manuals.

            Comment

            Previous template Next
            Working...