Hole punch question

[Valintine]

I have a kmc650 that I am trying to attach a used finisher model fs608 to. It is jamming as soon as it enters the finisher. When I pull the hole punch unit out the plungers are down. I have rotated them so they are all out of the way and when I power back up it jams the same way.

I just had a thought that the machine might not know that there is a hole punch in the finisher. Is there a setting in the service mode I can check to tell the machine what finisher and what option is in it?

Any thoughts would be appreciated.

Thank you

[JustManuals]

Re: Hole punch question

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from

http://www.justmanuals.com

Paul@justmanuals.com

[emujo]

Re: Hole punch question

Enter service mode..Finisher Adjustments, punch settings..select PK 513 2/3 hole and power cycle. Next you have to go back into service mode and perform the punch edge detection..Emujo