bizhub 350 says out of toner when printing

[DOE]

i have a konica 350 that is full of toner and copies fine but when they go to print it says its out of toner,. this happened after a big storm. dont nknow much about the print option. do i need a new print unit? thanks for any advice

[KM7155]

Re: bizhub 350 says out of toner when printing

u mean "full of toner" is ur toner bottle full of toner or the toner hopper full of toner?
if ur toner bottle full of toner, ur toner bottle probably did not turn.
have to make sure the toner hopper is working, normally the toner sensor is in the hopper
unit.

[Hansoon]

Re: bizhub 350 says out of toner when printing

@ KM7155: Perhaps when you shorten toner to ton, hopper to hop, bottle to bot and probably to prob it would be easier to understand your writing.

Good grieve.......

Hans

[KM7155]

Re: bizhub 350 says out of toner when printing

@ KM7155: Perhaps when you shorten toner to ton, hopper to hop, bottle to bot and probably to prob it would be easier to understand your writing.

Good grieve.......

Hans

@Hans, are u facing difficulty to understand my writing?

[Hansoon]

Re: bizhub 350 says out of toner when printing

@Hans, are u facing difficulty to understand my writing?

Yes.

Hans

[KM7155]

Re: bizhub 350 says out of toner when printing

Yes.

Hans

Haha, too bad.

[pepper38_cnd]

Re: bizhub 350 says out of toner when printing

In the print driver Port setting uncheck the SNMP box, you should not see any messages from the printer with this unchecked. Also make sure in the configure tab, under aquire settings the Auto box is unchecked.

[JustManuals]

Re: bizhub 350 says out of toner when printing

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com