Hello once more,
I have paper stopping without any leading edge damage at about 2-5mm past the Tray 2 Vertical transport sensor (PC2), when fed from tray 2 or machine bypass.
There is firm drive to the transport rollers just below the sensor
The sensor is read correctly from service mode.
The lower tray (LCC, PF122) also feeds fine.
I have replaced the feed (CL4) & transport (CL2) clutches.
Help please...
I have paper stopping without any leading edge damage at about 2-5mm past the Tray 2 Vertical transport sensor (PC2), when fed from tray 2 or machine bypass.
There is firm drive to the transport rollers just below the sensor
The sensor is read correctly from service mode.
The lower tray (LCC, PF122) also feeds fine.
I have replaced the feed (CL4) & transport (CL2) clutches.
Help please...