C-360 hangs up ay stabilization

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • selmila
    Trusted Tech

    100+ Posts
    • Aug 2012
    • 133
    #1

    C-360 hangs up ay stabilization

    Hi,
    can i get help on KM C-360,
    The machine was having problem with the RAM that i have replaced it and after replacing the RAM the m/c comes alive but stuck up at stabilization and the start button blinks in orange and never comes to Ready to copy mode. any suggestions to this problem.
    Tags: None
    • JSC
      Gimp

      500+ Posts
      • Dec 2006
      • 618
      #2
      Re: C-360 hangs up ay stabilization

      Why did you replace the RAM? Have you replaced it with the same type, clock speed etc?

      have you tried updating/reloading firmware? Etc......
      The gene pool could use a little chlorine.

        Comment

        • JustManuals
          Field Supervisor

          5,000+ Posts
          • Jan 2006
          • 9838
          #3
          Re: C-360 hangs up ay stabilization

          This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


          Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


          Paul@justmanuals.com

            Comment

            • RRodgers
              Service Manager

              1,000+ Posts
              • Jun 2009
              • 1947
              #4
              Re: C-360 hangs up ay stabilization

              Have you cleaned the sensors that are under the t belt?
              Color is not 4 times harder... it's 65,000 times harder. They call it "TECH MODE" for a reason. I have manual's and firmware for ya, course... you are going to have to earn it.

                Comment

                • selmila
                  Trusted Tech

                  100+ Posts
                  • Aug 2012
                  • 133
                  #5
                  Re: C-360 hangs up ay stabilization

                  Originally posted by JSC
                  Why did you replace the RAM? Have you replaced it with the same type, clock speed etc?

                  have you tried updating/reloading firmware? Etc......



                  The RAM was replaced because there was no display and no engine worming up,but only the power light glows and the start button glows in orange.The machine is in ready to copy mode now but start button still glows in orange and unable to take copys /print even in the service mode.
                  I have not reloaded the firmware,could it be the firmware issue??? can anyone send me the firmware and the movie data,thanks.
                  Last edited by selmila; 04-24-2013, 08:00 AM.

                    Comment

                    • HoonBoy
                      Trusted Tech

                      100+ Posts
                      • May 2011
                      • 130
                      #6
                      Re: C-360 hangs up ay stabilization

                      Try replacing HDD (or disable temporary)...

                        Comment

                        Previous template Next
                        Working...