Minolta DI-450 Error C1330

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Jack
    #1

    Minolta DI-450 Error C1330

    Have a Minolta DI-450 with error code c-1330 on display. Does anyone any suggestions as to what is causing the problem.
    Thank You
    Jack
    Tags: c-1, c1330, di450, error, minolta, off, pluged, print control board
    • Raymondd
      Service Manager

      100+ Posts
      • Jan 2008
      • 108
      #2
      Jack,
      Did you open and close the front door and turn copier off/on?

        Comment

        • chuckt528
          Technician
          • Apr 2008
          • 32
          #3
          Reset, as Jack said. If problem comes back at least 3 times check/replace main or print control board

            Comment

            • chuckt528
              Technician
              • Apr 2008
              • 32
              #4
              If recurring, main or image process boards.

                Comment

                • ni311
                  Senior Tech

                  Site Contributor
                  500+ Posts
                  • May 2008
                  • 658
                  #5
                  C1330
                  VD signal error
                  A LOW VD signal is not detected even after the lapse
                  of 60 sec. after an IDREQ signal has been output.
                  Konica Minolta Error Codes - Explanations and Solutions

                    Comment

                    • Jack
                      #6
                      Thank all for this info. I unpluged all the conection on the A Board then repluged them and it works great.
                      Thank You All Much
                      Jack

                        Comment

                        Previous template Next
                        Working...