Hello, I have a code C-2861 with Konica C6500, help me!

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • ads.voucher
    Junior Member
    • Apr 2013
    • 5
    #1

    [Error Code] Hello, I have a code C-2861 with Konica C6500, help me!

    Hello,

    I have a code C-2861 with Konica C6500, help me!

    Thanks
    Tags: 286, 500, c650, c6500, code, help, konica, konica c6500, service manual
    • JustManuals
      Field Supervisor

      5,000+ Posts
      • Jan 2006
      • 9838
      #2
      Re: Hello, I have a code C-2861 with Konica C6500, help me!

      This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


      Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


      Paul@justmanuals.com

        Comment

        • wseyller
          Service Manager

          1,000+ Posts
          • Sep 2012
          • 1129
          #3
          Re: Hello, I have a code C-2861 with Konica C6500, help me!

          Indicated gamma correction failure for the yellow. Means the patches made on transfer belt are not good. Run some test prints for yellow to start troubleshooting image defects.

            Comment

            • methogod
              Senior Tech

              Site Contributor
              500+ Posts
              • Dec 2008
              • 917
              #4
              Re: Hello, I have a code C-2861 with Konica C6500, help me!

              Tech mode...

              test print

              set yellow and blue to 160

              press copy at the top...

              make sure you set to full color...

              print a few 12x18 or 11x17 pages. see what you get.


              yellow is the hardest color to figure out.

              always easier to mix with blue and look for whats missing in the GREEN output, because yellow and blue make green. right.


              would check your DV unit, make sure toner is moving though it ok, make sure the little 2 pin wire is plugged in up front, that shouldnt be the reason but i would check it anyway.

              THEN POST PICS, of the output and the display - need to see where the consummables are at - seen belt age cause problems.

                Comment

                Previous template Next
                Working...