Reset meter count on bizhub c451

[Lasersupplies]

Hi All,

I am wondering is there away to reset the page meter count on a bizhub c451? Thanks

[emujo]

Re: Reset meter count on bizhub c451

Although meter counts do get accidently reset (NVRAM Change out etc) it would be unethical at the least, and illegal at the worst to do this on purpose. Similar to winding back the odometer of your car prior to selling it. I'm sure your reasons are not nefarious, but sorry, won't help on this one. If you are looking to reset the PM counts and have just misstated your header then you might get some info. Emujo

[a4o7910]

Just same inposible

[a4o7910]

Nvram cleare.but count it save in oder chip

[EarthKmTech]

Re: Reset meter count on bizhub c451

new nvram required and physically resetting the mechanical counter / replacing it.

and btw, KM wont give you new nvram for this purpose anyway.

[TheOwl]

Re: Reset meter count on bizhub c451

Just wondering if there is a way I can reset the count on my power meter. The pricks keep coming around and charging me for power, so I thought I would stuff them up and reset the count....

Why poeple, WHY???

About time we got a forum group, called it "Meter Count Resets" so these idiots can post all their "I rebuilt the machine so I can reset the meter count" in there and we can simply ignore them!!!

[emujo]

Re: Reset meter count on bizhub c451

I wasn't quite ready to call him an "outlaw"...no way I'm assisting in meter resets, but I was curious as to why he wanted to know. Emujo

[sangcom]

Re: Reset meter count on bizhub c451

NVRAM C451 can clear all (total counter)by use bizhub 500 by use load check mode of bizhub 500

[EarthKmTech]

Re: Reset meter count on bizhub c451

you can also clear it by reversing the tire over it in your car too.

anyone looking for a used copier should be suspicious of ultra low meter counts - you can mostly tell by just looking at the machine if its fake. A machine with under 1000 pages on the clock isnt going to have bald tray rollers, worn through button tops on the control panel, a transfer belt that looks like a vinyl record etc etc etc.

good thing about the panels these days as theyre not rebuildable and are expensive - cheapskates that do this arent going to replace them unless theyre dead, so its a dead give away.

if in doubt, get an independant tech to look at it - if its a heap of shit he'll let you know.

[Lasersupplies]

Re: Reset meter count on bizhub c451

Hi, I have been off for a few weeks. Just to set the record straight, by no means would I be trying to reset the overall counter of the machine as a tech it goes against the grain and also would make no sense as an aging machine causes more problems than its worth. I was looking to reset the maintenance page counts and was provided accurate assistance.

[Kenzo123]

Re: Reset meter count on bizhub c451

put some new paper in exit tray and print reversly... maybe u get to 0:P