hi , I hope that someone can help me with this code c 4501 /c4502 .I tried to reset the skew adjust for printhead yellow ,did the gamma adjust ok but still the code reappear , I think its the prcb board ,plz any suggestion could help me
-
-
Re: c6000
Hi,
Was both sides adjustment being performed when these codes appeared?
Before replacing the PRCB i would perform the write unit initial position adj. This may ge tthe machine out of error.
If this doesnt work then replace the PRCB. -
Re: c6000
This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from:
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.comComment
Comment