df 614 jam on a bizhub 601

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • brent
    Service Manager

    Site Contributor
    1,000+ Posts
    • Nov 2008
    • 1208
    #1

    df 614 jam on a bizhub 601

    has anyone had problems with the lift plate on this doc feeder the df 614 on the konica minolta bizhub 601? I caught the machine just not lifting it when it should have. I see there is a motor and a gear train that lifts the plate to feed each original. but it is too fast and random jamming to catch it. any thoughts? thanks again

    brent
    Tags: None
    • brent
      Service Manager

      Site Contributor
      1,000+ Posts
      • Nov 2008
      • 1208
      #2
      Re: df 614 jam on a bizhub 601

      the darn machine seems to be working very good now. that is my luck right?

      brent

        Comment

        • SmellsHot
          Head Tech

          500+ Posts
          • Dec 2009
          • 512
          #3
          Re: df 614 jam on a bizhub 601

          You can lift up the metal lift plate....underneath the plate and at the rear you will see the driving gears. Very common for them to get gunked up with paper scraps and cause lifting issues /noises/jamming.....Just clean the teeth out with a flat blade. I've made this a MCP for any DF issues
          Everyone has the right to be stupid. Some people just abuse this privelage more than others

            Comment

            • Synaux
              Service Manager

              Site Contributor
              1,000+ Posts
              • Mar 2012
              • 1224
              #4
              Re: df 614 jam on a bizhub 601

              Originally posted by brent
              has anyone had problems with the lift plate on this doc feeder the df 614 on the konica minolta bizhub 601? I caught the machine just not lifting it when it should have. I see there is a motor and a gear train that lifts the plate to feed each original. but it is too fast and random jamming to catch it. any thoughts? thanks again

              brent
              A few weeks ago, I thoroughly cleaned one due to jams (and it was filthy)--I did not go into the gears, but will next time I am there.
              Anyways, it stopped jamming. I made it feed close to 1k times then another 200 or so duplex. Not a single jam.

              I hear its jamming again a week later...

                Comment

                • JR2ALTA
                  Service Manager

                  Site Contributor
                  1,000+ Posts
                  • Feb 2010
                  • 2028
                  #5
                  Two critical one-ways. One on rear of top cover and one on rear of reg section that lifts up.

                  At very least clean shaft and one ways.

                  Also a sensor gets dusty underneath black plate in turnaround section, when you lift up df.

                  Pretty much everything but the rollers cause jamming on this model

                    Comment

                    • brent
                      Service Manager

                      Site Contributor
                      1,000+ Posts
                      • Nov 2008
                      • 1208
                      #6
                      Re: df 614 jam on a bizhub 601

                      I will have to check that out. Because the damn thing is working now
                      But I'll be back soon. It has 1.3 mill on it

                        Comment

                        Previous template Next
                        Working...