[Error Code] Please help me.......this problem ......

[chadson]

hi guys.

yesterday, i was update my Fiery Fiery X3eTY2 65-55C-KM 2.0.....when i get restart is appearce error code.2014-02-27_092354.jpg 2014-02-27_093600.png

i can not printting.

please fix my error code.

thank you a lot Mode and everyone...

[chadson]

Re: Please help me.......this problem ......

hi guys.

yesterday, i was update my Fiery Fiery X3eTY2 65-55C-KM 2.0.....when i get restart is appearce error code.[ATTACH=CONFIG]24137[/ATTACH] [ATTACH=CONFIG]24138[/ATTACH]

i can not printting.

please fix my error code.

thank you a lot Mode and everyone...

helpppppppp

[habik]

Re: Please help me.......this problem ......

helpppppppp

You need 7 things:

1, Stop shouting and think!
2, Get a Service Manual for the Fiery
3, Get Fiery USB Flash Tool
4, Download again!! Fiery Software v2.0
5, Get USB Key 2 GB and format it and put the Fiery Software on it using USB FLASH TOOL!
6, If you have the Fiery Service Manual read again the procedure.
7, Go to step 1


PS. Get in touch with Paul@justmanuals.com

[Mick01]

Re: Please help me.......this problem ......

Hi,
I agree with Habik, there was an issue with the reload.
One thing to note the system software is too big for a 2gb usb stick. minimum 4gb is required.
You can also try and run the installer on the V2 System disk with your computer connected directly to the fiery with a cross over cable. The installer has a step by step procedure to follow. I have had a faulty HDD cause these types of errors when trying to reload. A new HDD might be worth a try also.
Hope this helps to get you back running again.

[habik]

Sorry about the usb stick! I am using it on everything got so used to it. Mick is right! Thanks fort that , Mick



Sent from my iDon't believe in marketing device using Tapatalk

[chadson]

Re: Please help me.......this problem ......

i install by Lan.....connect PC

[chadson]

Re: Please help me.......this problem ......

2014-02-28_170726.jpg2014-02-28_170428.jpg

please help me.....i can not print this file......

My copie could print file <2mb .......can not print file >4mb

thank you so much.....

[DigiMan]

Re: Please help me.......this problem ......

If im seeing correctly your file is a JPEG and as far as i remember CW cannot handle JPEG files.

[chadson]

Re: Please help me.......this problem ......

If im seeing correctly your file is a JPEG and as far as i remember CW cannot handle JPEG files.

are you sure......i think that support any thing file.....

Please help me..............