KM C6500 force Saddle Stitchng when using 163-209 on 100lb text

[Topstep1]

Hey guys. I am in an environment that likes the curing effect of 163-209 paper weight setting (higher heat than 81-105). The problem is the printer (fiery front end) does not like to Saddle Stitch/fold and staple on this paper weight setting.

It there a way (supported or not) to 'force' it to fold and staple 11x17 100lb Text and not be limited to 81-105 paper weight setting

I once tried making a Postscript file using the PPD for the printer and making the settings there but alas, no go.

I'm open to try any suggestions and report back the results.

Best Regards

[Topstep1]

Re: KM C6500 force Saddle Stitchng when using 163-209 on 100lb text

Anybody?

[Topstep1]

Re: KM C6500 force Saddle Stitchng when using 163-209 on 100lb text

Good Morning, It anyone has any insight into my problem above, I am standing by and grateful for the share.

[jzheld]

Re: KM C6500 force Saddle Stitchng when using 163-209 on 100lb text

Good Morning, It anyone has any insight into my problem above, I am standing by and grateful for the share.

It will not let you send it to saddle , the only way is to lower the setting, but you might get to another problems, ether jamming or toner is not fusing to the paper.