KM C454e olivetti MF452 c-2551 error code

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • printerguy77
    Technician
    • Feb 2014
    • 26

    #1

    KM C454e olivetti MF452 c-2551 error code

    Hi All,

    i have the above error code and the cyan dev unit was just at end of life so i replaced it and the fault cleared, that was about 3 weeks ago and it has now come back with the same error code.

    Anyone had this before?

    regards

    colin
  • PeterG
    Trusted Tech

    100+ Posts
    • Jul 2008
    • 177

    #2
    Re: KM C454e olivetti MF452 c-2551 error code

    Have you checked the cyan toner density level in "state confirm"?
    If it low, does it increase when you run toner re-supply?

    Comment

    • Max
      Senior Tech

      500+ Posts
      • Oct 2011
      • 559

      #3
      Re: KM C454e olivetti MF452 c-2551 error code

      Did you clean the 2 IDC sensors/laser glass? Did the IU counter reset with the new I.U? If not then it will be using he data from the old I.U and destroying it.
      Last edited by Max; 06-10-2014, 11:03 AM.

      Comment

      • printerguy77
        Technician
        • Feb 2014
        • 26

        #4
        Re: KM C454e olivetti MF452 c-2551 error code

        By the 2 ids sensors I presume you mean the sensors on the transfer belt. These are clean but have nothing to do with tcr control. My cyan is reading 0.00 in service mode and the other 3 colours are reading normally. I have even poured toner straight into the developer tank.

        C

        Comment

        • Max
          Senior Tech

          500+ Posts
          • Oct 2011
          • 559

          #5
          Re: KM C454e olivetti MF452 c-2551 error code

          IDC* my mistake. If the reading is 0.00. Is the physical connection ok on the IU and the copier itself? Damaged pin perhaps or something preventing the IU being fully in, yet enough to see it.

          Comment

          • printerguy77
            Technician
            • Feb 2014
            • 26

            #6
            Re: KM C454e olivetti MF452 c-2551 error code

            Originally posted by Max
            IDC* my mistake. If the reading is 0.00. Is the physical connection ok on the IU and the copier itself? Damaged pin perhaps or something preventing the IU being fully in, yet enough to see it.
            I've had the developer unit out several times at this stage. I have just requested a new prcb. Fingers crossed. I have changed the toner low sensor and swapped the hopper drive motor also. These damn machines are starting to wreck my head. Anyone else?

            Comment

            • stevena86
              Trusted Tech

              100+ Posts
              • Oct 2012
              • 130

              #7
              Re: KM C454e olivetti MF452 c-2551 error code

              Try the FREYB. It's the board on the front of the machine that all of the developers plug in to. I've had one go bad and it wouldn't see the new drums/developers that I put in the machine.

              Comment

              Working...