If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a customer with a Konica 7075, the seal on the edge of the dev lid is curled causing misting over the charge corona. The lid is no longer available. Does any one have a fix for this?
I have a customer with a Konica 7075, the seal on the edge of the dev lid is curled causing misting over the charge corona. The lid is no longer available. Does any one have a fix for this?
Found a solution for this, the charge seal used on the Konica 600 part # 56QA25010 fit perfectly, it took 3 seals for the length of the lid.
Comment