Few minutes After power " on " the machine, the massage, " warming up , ready to scan " appears but " ready to copy" massage not displayed , Pls inform me the solution.( fuser lamp off )
-
-
Re: KONICAMINOLTA BIZ-600/750
Clean your Toner Control Sensor Board, attempt Maximum Density Adjustment, if that doesn't work replace the TCSB, and try Maximum Density Adjustment again. If that doesn't work you are probably looking at replacing a Printer Control Board.
Edit: I just noticed you said the fuser lamp was off...I'd check the continuity of the lamps also...but from my experience and what I've seen on here it's likely the TCSB or Printer control board."In a cruel and evil world, being cynical can allow you to get some entertainment out of it."
Comment