If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
1/Perform image troubleshooting procedure if image density is low.
2/Clean the TCR sensor window on the underside of the imaging unit if dirty
3/Reinstall imaging unit
4/Reinstall toner cartridge
5/M9, M13 operation check (At this time, IU must be non-installation.)
6/If the toner empty sensor and its surroundings inside the sub hopper are dirtied with toner, clean them
7/Replace Yellow IU
Comment