Di 450/550

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • copycommerce
    Technician

    50+ Posts
    • May 2008
    • 65

    #1

    Di 450/550

    Hello ,
    i have a Di 450 with controller,scan board,upg.memory and hard drive.When i put the machine on the sensor for the hard lightes green and that means that the machine recognize it,but still i can't either format it or check it.In service mode in function when i sellect hard drive ON it gets a code.The question is what can cause the machine first to recognize the hard and then to not make a connection with it?Do i need to place the "jumper" on some specific slot(now is at the first).Any ideas are welcomed
  • deep
    Trusted Tech

    100+ Posts
    • Jun 2008
    • 208

    #2
    Green light means the hard drive is connected just like a new hard drive in the computer.

    The machine will not reconizes the hard drive before it is being formatted or it is fail or the data is corrupted.

    Make sure the hard drive is good before you can format it.
    Kenny

    Comment

    Working...