If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hello . I have a problem on the copier pro1051 . When you print a book of 30 pages , is a problem that image once dark , sometimes pale . Not straight-line printing throughout the procedure . Has anyone had a similar problem?
Hello . I have a problem on the copier pro1051 . When you print a book of 30 pages , is a problem that image once dark , sometimes pale . Not straight-line printing throughout the procedure . Has anyone had a similar problem?
I have seen this I would change dev run all set ups for dev change. then go into test chart pint outs and run 200 of test chart 12.
clean the sensors near the drum and install a new charge corona
I firs clean the sensor on the drum vith alcohol, and replace the corona, drum and developer, make all the setting vhen replace the drum, but it was the same s..t
Comment