I have a Konica 7115 and the maintenance wrench light is on. I have drum, blade, and developer to change for the machine. I checked the count for the PM and it was 32k. Short of the 40k, but copy quality is pretty bad, so we will change it a little early.
I went into service mode, --3, but I can't reset the PM count to get the light to go out. When I hit the button to save the 0 count, I get "Err" on the panel.
We haven't been able to locate anything in the manual for the Err displayed message. Any help you can provide would be greatly appreciated.
Thanks.
I went into service mode, --3, but I can't reset the PM count to get the light to go out. When I hit the button to save the 0 count, I get "Err" on the panel.
We haven't been able to locate anything in the manual for the Err displayed message. Any help you can provide would be greatly appreciated.
Thanks.
Comment