This one acts like it just can't calibrate it's gradient right...
Prints good, but when you copy something, it reads/prints lighter areas poorly. Like it's calling light colors as not there.
Printed a test page, looked good, but when copied, looks like this, looks same on glass or in adf.
Ran gradient calibration twice, no change. Any thoughts?
Prints good, but when you copy something, it reads/prints lighter areas poorly. Like it's calling light colors as not there.
Printed a test page, looked good, but when copied, looks like this, looks same on glass or in adf.
Ran gradient calibration twice, no change. Any thoughts?