I have a brand new machine that is Printing from memory a copy that is squed about 1mm top and bottom. This machine it out of box. Nu world want me to send it back so they can adjust. My customer would like it Monday. Any Ideas? thanks Ray..
-
-
Re: M 3040IDN squed
I am interpreting your question as a 1mm skew. Check the paper tray guides and make sure they are good. Is it doing it from the manual tray also ?. The registration roller assy is supposed to correct skew issues, before the paper reaches the drum.
1mm should be hard to notice and may be in the skew tolerance range.THE ONLY THING FOR EVIL TO TRIUMPH IS FOR GOOD MEN TO DO NOTHING..........edmund burke -
Re: M 3040IDN squed
OK I am a bad speler.... Thanks for reply. I have not tried from the bypass good point. I will try that. the skew is 1.5mm looks off. duplex that and 3mm looks ugly....Otherwise love the operation system and machine...Comment
-
Re: M 3040IDN squed
I have looked again and the top is pretty good the bottom is skewed 3mm. I am not trained on the latest tec codes. I can get in and adjust the paper timing but not sure about the different names. I adjusted the cassette and duplex but there are others. I have re seated the registration roller. thanks RayComment
-
Re: M 3040IDN squed
post a pic of the page with the skewed image. There is not electronic adjustment for skew, that is handled by the registration roller assy. The paper tray guides, the pre registration feed roller and registration roller handles the skew adjustment. maybe, one of the registration spring is not right. Replace the machine, as it is new out of box.THE ONLY THING FOR EVIL TO TRIUMPH IS FOR GOOD MEN TO DO NOTHING..........edmund burkeComment
-
Re: M 3040IDN squed
I would love to replace the machine but I am the low man on the totem pole no one wants to do shit. I have increased the buckle and made the sale fly. Now its a snake in the grass..........Comment
Comment