KM 1620 showing C6

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • DadO
    Trusted Tech

    Site Contributor
    250+ Posts
    • Dec 2007
    • 401
    #1

    KM 1620 showing C6

    I never worked on this machine and i will need help from u guys since I am trained for canon and konica minolta machines.

    Costumer told me that C6 message shows right at start. I saw its related whit fuser code and thats obout it . I dont know counter since i didn't saw machine jet.

    What can i do obout this code. Can i try to reset it (and how can i do it) or i need to replace/clean something.


    THANK U
    Tags: 1620, act, maintenance mode, rotated, showing
    • termacadon
      IT goofball

      50+ Posts
      • Oct 2008
      • 66
      #2
      The code is related to a fuser error, you can reset it in simulation 163.

      type 10871087 on the keypad. It will take you into service mode. If im not mistaken about this series. I have not worked on them in years!

        Comment

        • DadO
          Trusted Tech

          Site Contributor
          250+ Posts
          • Dec 2007
          • 401
          #3
          as far i got; type 10871087 then type 163 and then what?

            Comment

            • D Colour
              Trusted Tech

              Site Contributor
              100+ Posts
              • Oct 2008
              • 213
              #4
              Everything that has a beginning, has an end.....

                Comment

                • DadO
                  Trusted Tech

                  Site Contributor
                  250+ Posts
                  • Dec 2007
                  • 401
                  #5
                  THX D color and Termacadon. Without right right key i could press any key for whole day and wouldn't make any difference

                  THX again

                    Comment

                    • DadO
                      Trusted Tech

                      Site Contributor
                      250+ Posts
                      • Dec 2007
                      • 401
                      #6
                      Info on c6

                      One heater is broken where contact is made. I rotated heater so when u place upper part of fuzer on pressure roll, heater drops on contact and there u go.Not bad for kyocera. Very simple design and thumb up at least for this machine.

                      This is dangerous but until i dont get replacment.....

                      One other thing i would ask is the part number of heaters since i dont have PM. M?or S?. The one that is broken is placed between paper separation and the other, lets say in middle. Is that M?

                        Comment

                        • ParishinIreland
                          #7
                          Re: KM 1620 showing C6

                          Originally posted by DadO
                          Info on c6

                          One heater is broken where contact is made. I rotated heater so when u place upper part of fuzer on pressure roll, heater drops on contact and there u go.Not bad for kyocera. Very simple design and thumb up at least for this machine.

                          This is dangerous but until i dont get replacment.....

                          One other thing i would ask is the part number of heaters since i dont have PM. M?or S?. The one that is broken is placed between paper separation and the other, lets say in middle. Is that M?

                          Hi I am experiencing the same problem, the toner is not fused when it is coming out on the job tray, is there anyway of manually restarting the heater or could you tell me how you twisted it ? Cheers Nate.

                            Comment

                            Previous template Next
                            Working...