kyocera/mita

[hodgiepodgie]

how do i get into "service mode" to reset an error code on a( km5035) was using hole punch and sort poppped code now cant use finisher at all. assume need to restart somthing in copier anybody know how ?....service mode and how to reset so as too use finisher believe it was an 888 code but no code is diplayed at this time

[Jimbo1]

It's 10871087 just like the guy on here. That's the code to enter service mode.

The type in 906 and execute and it should restore operation.


Your welcome!

[hodgiepodgie]

thank you

[fitsy.13]

thank you

if its a fuser error you need 163 not 906