mita dc1860

[nos]

I was wondering if anyone knew or remembered how to adjust the exp. lamp on this model. I got a call on one that the copies get darker the more they run. Thanks for any help

[jaime]

10871087 enters service. enters the simulation 24 and increases the value copies will get clearer.
but beware of too high can have a code scanner because it affects the home position sensor. good luck

[jaime]

10871087 enters service. enters the simulation 24 and increases the value copies will get clearer.
but beware of too high can have a code scanner because it affects the home position sensor. good luck

[tcypy1961]

Sim 32 is another good one to use. Most likely drum is ready to be replaced. Be sure all mirrors and slit glass is cleaned.

[kyocera dave]

1860

Hold down the exp button & check where the exposure is set. If its high & you alter sim 24 then you might get problems. Clean optics etc, reset exposure to middle & then do sim 24.