Kyocera KM-3035

[vale24]

Hi, I'm not friendly with this brand and I want to ask how to activate the fax - I have two copiers, one of this copiers is about 500 000 copies (copy/fax/print/scan) and the other is 10 000 (only copier). I want to move fax, scanner, printer function (boards) to this with 10 000 pages. I did this yesterday, print is OK, scan is O.K. but FAX.... doesn't work(when you push the button it doesn't light). I don't have service manual and I don't know what to do in this case. Any Idea....

Thanks

[peterepeat]

The fax unit consists of 3 boards - the modular board(phone jack), fax controller, & power supply, as well as a few harnesses. The controller board is the one that the mod's harness goes in to & sits behind the print controller below the copier's main board. The power supply sits to the right of the mod board next to the power supply. Follow all the harnesses & you should find everything. Also be sure to take the flat ribbon cable that goes from fax cont to main board.
It's involved but not too bad.

[JustManuals]

This Parts & Service manual can now be purchased for $11.77 and downloaded immediately after payment
from The Internet's largest collection of manuals


Paul@justmanuals.com

[Tebow83]

whats your email address and i will send you a installation manual.

[aodtech]

Definitely check the ribbon cable in the back. It is VERY sensitive. Sometimes it takes me a couple of tries to get the fax button to light up when I move a Fax system.

[10871087]

Definitely check the ribbon cable in the back. It is VERY sensitive. Sometimes it takes me a couple of tries to get the fax button to light up when I move a Fax system.

We hate to move that fax system from machine to machine, but sometimes you gotta do what you gotta do.

[Scott]

3035 issues

I have seen this problem and I have corrected it by updating the firmware

[Jules Winfield]

Also, don't forget about initializing the fax board after installation. (Sim 600, I think. I know it's somewhere in the 600s though).

[vikingmita]

guess you're missing something with the power board. faulty ribbon cable or wrong firmware usually means error codes.

[vale24]

e-mail

Hi, thanks for advice, but I did this and fax doesn't work, for this reasone i decide that may be I have to activate this fax in service mode. My email is valentin.georgiev@yahoo.ca!

Thanks