copystar 2050 firmware

[Guest]

2050 does not recognize DP410 after repairing power board in unit. Was suggested may need to update firmware. I no longer have code to get from copany site, is there any where else I might get it. Have been out of the business for 18 months, need to fix copier in my wifes office.
any help would be appreciated.
Bob T.

[Hutcheson]

It sounds like you need to run Sim 906 to reset partial operation control. You get into sim by entering 1087087.

[bktack97]

2050 firmware

Have already done that, thought it might be the harness connecting dp to copier, all wires are ok. Just will not recognize the dp is there. One other tech suggested trying the firmware or reinitializing, don't know if I want to risk that.

[garg]

2050 firmware

have you an email address lets have it garg

[charly]

sometimes it breaks a small fuse in engine board ,and does not recognize the dp. make a bridge

[bktack97]

My e-mail bktack97@excite.com. Fuse located on the main drive board in back of copier?