How do you get any good colors from a Taskalpha 4ooci? I have one that when you copy the colors are not even close on business color not photos. The grays have a tough of magenta tint to it. Prints are better but not correct. I have replaced The CCD, developer units, and drums. Did laser clean, drum refresh, developer refresh, color calibration, color registration, and auto gray adjustments. Any suggestions?
-
-
Have you udated the firmware and can you post a color reg sample -
x2 for the firmware. BTW, that's an expensive repair, you're not going to make money with this machine.Comment
-
And i thought I had problems with the Task colors.
keep us updated. These things are handfulls. I have replaced several engine boards already.Comment
-
Ditto on the firmware (v11) and vac out/ clean the machine, clean ID sensors, make sure you do simm 464 Ac cal, 410,412 & try loading the bizhub colour table, which you should be able to get from your RTM if you havn't already got it.
Post some samples if you can.
Good LuckThe gene pool could use a little chlorine.
Comment
-
Replaced the color drums and developers and the colors are good again.Comment
-
try different emulation. The latest driver has pdf emulation enabled.Idling colour developers are not healthy developers.Comment
Comment